燃氣發電機組對燃氣的要求：

Gas generator set's requirements for gas:

1、燃氣發電機組對天然氣的要求在距離機組燃氣進氣調壓閥前1m內，①天然氣壓力100～300kPa（增壓機）或50-300kPa（非增壓機）；②天然氣中甲烷體積含量不低于70%；③H2S≤20mg/Nm3；④雜質粒度＜5μm，雜質含量≤30mg/Nm3；

1. The requirements for natural gas in gas generator sets are within 1 meter before the gas inlet pressure regulating valve of the unit, with a natural gas pressure of 100-300 kPa (for turbochargers) or 50-300 kPa (for non turbochargers); ② The methane volume content in natural gas shall not be less than 70%; ③H2S≤20mg/Nm3； ④ Impurity particle size<5 μ m, impurity content ≤ 30mg/Nm3;

若可燃氣體中含硫及氨成份較高，不僅會嚴重腐蝕火花塞電極，而且會使機油中酸值增加，腐蝕機組內部零件，同時易于生成沉淀物，增加對發動機的腐蝕和磨損。

If the combustible gas contains high levels of sulfur and ammonia, it will not only severely corrode the spark plug electrode, but also increase the acid value in the engine oil, corrode the internal parts of the unit, and easily generate sediment, increasing the corrosion and wear of the engine.

2、燃氣發電機組對沼氣的要求在距離機組燃氣進氣調壓閥前1m內，①沼氣溫度≤40℃；②沼氣壓力3～10kPa，壓力變化速率≤1kPa/min；③沼氣中甲烷體積含量不低于40%，變化速率≤2%∕min；④H2S≤200mg/Nm3；⑤NH3≤20mg/Nm3；⑥雜質粒度≤5μm，雜質含量≤30mg/Nm3；⑦沼氣中水份含量≤40g/Nm3。對于甲烷體積含量30～40%的沼氣需要機組特殊配置，選另一型號的產品。

2. The requirements for biogas in gas generator sets are within 1 meter before the gas inlet pressure regulating valve of the unit, with ① biogas temperature ≤ 40 ℃; ② Biogas pressure is 3-10kPa, with a pressure change rate of ≤ 1kPa/min; ③ The methane volume content in biogas is not less than 40%, and the rate of change is ≤ 2%/min; ④H2S≤200mg/Nm3； ⑤NH3≤20mg/Nm3； ⑥ Impurity particle size ≤ 5 μ m, impurity content ≤ 30mg/Nm3; ⑦ The moisture content in biogas is ≤ 40g/Nm3. For biogas with a methane volume content of 30-40%, special configuration of the unit is required. Choose another model of product.

若可燃氣體中含硫及氨成份較高，不僅會嚴重腐蝕火花塞電極，而且會使機油中酸值增加，腐蝕機組內部零件，同時易于生成沉淀物，增加對發動機的腐蝕和磨損。

If the combustible gas contains high levels of sulfur and ammonia, it will not only severely corrode the spark plug electrode, but also increase the acid value in the engine oil, corrode the internal parts of the unit, and easily generate sediment, increasing the corrosion and wear of the engine.

3、燃氣發電機組對瓦斯的要求在距離機組燃氣進氣調壓閥前1m內，①瓦斯溫度≤40℃；②瓦斯壓力3～10kPa，壓力變化速率≤1kPa/min；③瓦斯中甲烷體積含量不低于9%，變化速率≤2%∕min；④對于甲烷體積含量小于30%的瓦斯，甲烷與氧氣體積含量之和不低于28%，氧氣體積含量不低于16％；⑤雜質粒度≤5μm，雜質含量≤30mg/Nm3。⑥硫化氫含量不大于200mg/m3。對于超出規定范圍的氣體需與廠商溝通，根據氣體成份核實是否可行。

3. The gas generator set requires a gas temperature of ≤ 40 ℃ within 1m before the gas inlet pressure regulating valve of the unit; ② Gas pressure 3-10kPa, pressure change rate ≤ 1kPa/min; ③ The methane volume content in gas is not less than 9%, and the rate of change is ≤ 2%/min; ④ For gases with methane volume content less than 30%, the sum of methane and oxygen volume content shall not be less than 28%, and the oxygen volume content shall not be less than 16%; ⑤ Impurity particle size ≤ 5 μ m, impurity content ≤ 30mg/Nm3. ⑥ The hydrogen sulfide content shall not exceed 200mg/m3. For gases that exceed the specified range, it is necessary to communicate with the manufacturer and verify the feasibility based on the gas composition.

4、燃氣發電機組對焦爐煤氣的要求在距離機組燃氣進氣調壓閥前1m內，①焦爐煤氣溫度≤40℃；②焦爐煤氣壓力3～10kPa，壓力變化速率≤1kPa/min；③焦爐煤氣中氫氣體積含量≤60%；④H2S≤200mg/Nm3；⑤NH3≤20mg/Nm3；⑥焦油含量≤50mg/Nm3；⑦雜質粒度≤5μm，雜質含量≤30mg/Nm3；⑧焦爐煤氣中水份含量≤40g/Nm3。

4. The requirements for coke oven gas in gas generator sets are within 1 meter before the gas inlet pressure regulating valve of the unit. ① The temperature of coke oven gas should be ≤ 40 ℃; ② The pressure of coke oven gas is 3-10kPa, and the rate of pressure change is ≤ 1kPa/min; ③ The volume content of hydrogen in coke oven gas is ≤ 60%; ④H2S≤200mg/Nm3； ⑤NH3≤20mg/Nm3； ⑥ Tar content ≤ 50mg/Nm3; ⑦ Impurity particle size ≤ 5 μ m, impurity content ≤ 30mg/Nm3; ⑧ The moisture content in coke oven gas is ≤ 40g/Nm3.

若可燃氣體中含硫及氨成份較高，不僅會嚴重腐蝕火花塞電極，而且會使機油中酸值增加，腐蝕機組內部零件，同時易于生成沉淀物，增加對發動機的腐蝕和磨損。

If the combustible gas contains high levels of sulfur and ammonia, it will not only severely corrode the spark plug electrode, but also increase the acid value in the engine oil, corrode the internal parts of the unit, and easily generate sediment, increasing the corrosion and wear of the engine.

本文由燃氣發電機組友情奉獻.更多有關的知識請點擊:http://m.newsletterv.cn我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

This article is a friendly contribution from the analysis of gas generator sets For more information, please click: http://m.newsletterv.cn We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message